|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
TS34063 Dc to Dc Converter Controller SOP-8 DIP-8 Pin Definition: 1. SC 5. Comp 2. SE 6. Vcc 3. CT 7. Ipk 4. Gnd 8. Vdriver General Description TS34063 is a monolithic switching regulator and subsystem intended for use as DC to DC converter. It contains an internal temperature compensated reference, comparator, controlled duty cycle oscillator with an active peak current limit circuit, drive and a high current output switch. The TS34063 is specifically designed to be incorporated in step-up, step-down and voltage inverting converter applications. TS34063 is offered in SOP-8 and DIP-8 package Features Power forward control circuit Operating voltage from 3V to 40V Low standby current Current limit adjustable Output switch current up to 1.5A Variable oscillator frequency up to 100kHz (max.) Output voltage adjustable Pin Description Name SC SE CT GND COMP. VCC IPK VDRIVER Description Switch Collector Switch Emitter Timing Capacitor Ground Comparator Inverting Input VCC Collector IPK Sense Driver Applications Charger xD-ROM, xDSL products DC to DC converter Ordering Information Part No. TS34063CD C3 TS34063CS RL Package DIP-8 SOP-8 Packing 50pcs / Tube 2.5Kpcs / 13" Reel Block Diagram 1/10 Version: A07 TS34063 Dc to Dc Converter Controller Absolute Maximum Rating Parameter Supply Voltage Comparator Input Voltage Range Switch Collector Output Voltage Switch Emitter Voltage Switch Collector to Emitter Voltage Driver Collector Voltage Driver Collector Current (note 1) Output Switching Current Power Dissipation DIP-8 SOP-8 Symbol VCC VFB VC(SW) VE(SW) VCE(SW) VC(DRIVER) IC(DRIVER) ISW PD Maximum 40 - 0.3 ~ 40 40 40 40 40 100 1.5 1.0 0.5 +125 -65 ~ +150 Unit V V V V V V mA A W o o Junction Temperature Range TJ Storage Temperature Range TSTG Note: Maximum package power dissipation limits must be observed C C Electrical Characteristics (VCC =5V, Ta =25oC; unless otherwise noted.) Parameter Oscillator (OSC) Frequency Charge Current Discharge Current Discharge to Charge current ratio Current Limit Sense Voltage Symbol FOSC ICHARGE IDISCHARGE IDISCHARGE / ICHARGE VIPK(SENSE) VCE(SAT) VCE(SAT) HFE IC(OFF) VREF REGLINE Test Conditions CT = 1nF, Vpin5= 0V VCC = 5V ~ 40V VCC = 5V ~ 40V Pin7 to VCC IDISCHARGE = ICHARGE ISW= 1A, pin1, 8 connected ISW= 1A, Id=50mA ISW = 1A, VCE= 0.5V VCE = 40V Min 24 24 140 5.2 250 --50 -1.225 Typ 33 30 200 6.5 -1.0 0.45 75 0.01 1.25 -- Max 42 42 260 7.5 350 1.3 0.7 -100 1.275 6 Unit KHz uA uA -mV V V -uA V mV Output switch (note1) Saturation Voltage Saturation Voltage DC current gain Collector off-state current Comparator Threshold Voltage Line regulation VCC = 3V ~ 40V -- Total device VCC = 5V ~ 40V, C T = 1nF, pin7= VCC, pin5> VTH, Supply Current ICC -3 5 mA pin2=Gnd, remaining pins open Notes1: Low duty cycle pulse techniques are used during test to maintain junction temperature as close to ambient temperature as possible Note 2: If the output switch is driven into hard saturation (non-Darlington configuration) at low switch currents (<=300mA) and high driver currents (>=30mA), it may take up to 2uS for it to come out of saturation. This condition will shorten the off time at frequencies >= 30KHz, and is magnified at high temperature. This condition does not occur with a Darlington configuration, since the output switch cannot saturate. If a nondarlington configuration is used, the following output drive condition is recommended: Forced Bata of output switch: Ic output / (Ic driver - 7mA*) >= 10 * The 100ohm resistor in the emitter of the driver divide requires about 7mA before the output switch conducts. 2/10 Version: A07 TS34063 Dc to Dc Converter Controller Electrical Characteristics Curve 3/10 Version: A07 TS34063 Dc to Dc Converter Controller Typical Application Circuit Test Line Regulation Load Regulation Output Ripple Efficiency Output Ripple with Optional Filter Conditions VIN= 8V~16V, Io= 175mA VIN = 12V, Io= 75mA to 175mA VIN =12V, Io= 175mA VIN =12V, Io= 175mA VIN =12V, Io= 175mA Results 30mV = 0.05% 10mV = 0.017% 400mVpp 87.7% 40mVpp Figure 7. Step Up Converter 4/10 Version: A07 TS34063 Dc to Dc Converter Controller Typical Application Circuit (Continue) Test Line Regulation Load Regulation Output Ripple Short Circuit Current Efficiency Output Ripple with Optional Filter Conditions VIN= 15V~25V, Io= 500mA VIN = 25V, Io= 50mA to 500mA VIN =25V, Io= 500mA VIN =25V, RL= 0.1m VIN =25V, Io= 500mA VIN =25V, Io= 500mA Results 12mV = 12% 3mV = 0.03% 120mVpp 1.1A 83.7% 40mVpp Figure 9. Step Down Converter 5/10 Version: A07 TS34063 Dc to Dc Converter Controller Typical Application Circuit (Continue) Test Line Regulation Load Regulation Output Ripple Short Circuit Current Efficiency Output Ripple with Optional Filter Conditions VIN= 4.5V~6V, Io= 100mA VIN = 5V, Io= 10mA to 100mA VIN =5V, Io= 100mA VIN =5V, RL= 0.1 VIN =5V, Io= 100mA VIN =5V, Io= 100mA Results 3mV = 120.012% 0.022V = 0.09% 500mVpp 910mA 62.2% 70mVpp Figure 11. Voltage Inverting Converter 6/10 Version: A07 TS34063 Dc to Dc Converter Controller Design Formula Table Test ton toff ( ton+ toff ) CT Ipk(switch) Rsc Step Up Step Down Voltage Inverting Vout + Vf ! Vin(min) Vcc(min) ! Vsat 1 f min 4.0 x 10 -5 Vout + Vf Vcc ! Vsat ! Vout 1 f min 4.0 x 10 -5 | Vout | +Vf Vcc ! Vsat 1 f min 4.0 x 10 -5 ton ton ton 2Iout(max) $ $ & ton # + 1! ! toff % " 2Iout(max) 2Iout(max) $ $ & ton # + 1! ! toff % " & # 0.3 $ $ Ipk ( switch) ! ! % " & Vin( min ) ' Vsat # $ $ Ipk(switch) ! * ton( max ) ! % " & # 0.3 $ $ Ipk ( switch) ! ! % " & Vin(min) ' Vsat ' Vout # $ ! * ton(max) $ ! Ipk ( switch) % " & # 0.3 $ $ Ipk ( switch) ! ! % " & Vin(min) ' Vsat # $ $ Ipk ( switch) ! * ton(max) ! % " L(min) Co & Iout * ton # $9 $ Vripple( pp) ! ! % " & Ipk ( switch)(ton + toff ) # $ ! $ ! 8Vripple( pp ) % " & Iout * ton # $9 $ Vripple( pp) ! ! % " Terms and Definitions Vsat = Saturation Voltage of the output switch. Vf = Forward Voltage drop of the rectifier. The following power supply characteristics must be chosen: Vin= Normal input voltage Vout: Desied Output voltage, |Vout| =1.25 (1+R2 / R1) Iout : Desired output current. fmin : Minimum desired output switching frequency at the selected values for Vin and Io. Vripple(p-p): Desired peak-to-peak output ripple voltage. in practice, the calculated capacitor value will need to be increased due to its equivalent series resistance and board layout. The ripple voltage should be kept to a low value since it will directly affect the line and load regulation. 7/10 Version: A07 TS34063 Dc to Dc Converter Controller SOP-8 Mechanical Drawing DIM A B C D F G K M P R SOP-8 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX. 4.80 5.00 0.189 0.196 3.80 4.00 0.150 0.157 1.35 1.75 0.054 0.068 0.35 0.49 0.014 0.019 0.40 1.25 0.016 0.049 1.27BSC 0.05BSC 0.10 0.25 0.004 0.009 0 7 0 7 5.80 6.20 0.229 0.244 0.25 0.50 0.010 0.019 Marking Diagram Y = Year Code M = Month Code (A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep, J=Oct, K=Nov, L=Dec) L = Lot Code 8/10 Version: A07 TS34063 Dc to Dc Converter Controller DIP-8 Mechanical Drawing DIP-8 DIMENSION DIM A B C D G J K L M MILLIMETERS MIN 9.07 6.22 3.18 0.35 0.29 3.25 7.75 MAX 9.32 6.48 4.45 0.55 0.31 3.35 8.00 10 o INCHES MIN 0.357 0.245 0.125 0.019 0.011 0.128 0.305 MAX 0.367 0.255 0.135 0.020 0.012 0.132 0.315 10 o 2.54 (typ) 0.10 (typ) Marking Diagram Y = Year Code M = Month Code (A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep, J=Oct, K=Nov, L=Dec) L = Lot Code 9/10 Version: A07 TS34063 Dc to Dc Converter Controller Notice Specifications of the products displayed herein are subject to change without notice. TSC or anyone on its behalf, assumes no responsibility or liability for any errors or inaccuracies. Information contained herein is intended to provide a product description only. No license, express or implied, to any intellectual property rights is granted by this document. Except as provided in TSC's terms and conditions of sale for such products, TSC assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sale and/or use of TSC products including liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent, copyright, or other intellectual property right. The products shown herein are not designed for use in medical, life-saving, or life-sustaining applications. Customers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify TSC for any damages resulting from such improper use or sale. 10/10 Version: A07 |
Price & Availability of TS3406307 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |